Installation method of mobile support for interactive board

Step 1: before installing the mobile support, please place the equipment horizontally on the flat table top (the screen is downward), and there must be a space between the conference plate and the table top for soft objects (such as glue, cotton cloth, foam, etc.) to avoid bumping on the surface of the equipment.

Step 2: before installing the bracket, please carefully check the specification and quantity of the bracket components and fasteners in the accessory package to ensure that they are correct.

Step 3: use 4pcs screws C to fasten the hanging arms of the two wall hanging supports. In order to ensure the stability and safety of the equipment, it is strictly forbidden to hang the equipment upside down. If the wall strip has been installed on the whole machine, ignore this step.

Step 4: fasten 4pcs casters e with 1pcs base plate l through 16pcs screws J. Ensure that each caster is connected with the base plate through 4pcs screws. Step 5: fasten 2pcs support D and 1pcs base plate l through g-g1-g2.

Step 6: fasten 1pcs diaphragm F and 2pcs support d with 4pcs screws H. Fasten 1pcs wall hanging plate A and 2pcs support d through 4pcs screws k-1-k2.

Selection of suspension height of the whole machine

1. The maximum allowable touch height a is selected according to the average height of the user. It is suggested that this height should not exceed 1.9m for convenience of operation.

2. Install the wall hanging plate to the vertical wall and other fixed places, and measure the height B from the top of the wall hanging plate to the ground to facilitate installation.

3. We can meet our touch needs by adjusting the distance C between the top of the equipment and the hanging arm groove and the height B between the wall hanging plate and the ground.

4. After the wall hanging plate is fixed, in principle, the height of the hanging arm shall be adjusted first, and the appropriate hole position shall be selected to meet the needs of our equipment operation.